how to connect bunker hill security camera to computer

Connect the Power Adapter’s cord to the Camera’s Power cord. Test each Camera's function in its intended location before mounting: Make sure location will remain within the Camera's Operating Temperature.Ģ. Make sure no strong light will shine directly into Camera Lens. Do not install the Camera facing out of a window. but still covers the desired viewing area. Select a location high enough so that it is out of reach of children. Do not install where there are thick walls or other obstructions between the Camera and Receiver. Route the cords so as to avoid a tripping hazard. Take into consideration the length of the Camera and Power Adapter’s cords. Verify that installation surface has no hidden utility lines before drilling or driving screws. When planning mounting location and angle: Note: The included Cameras are programmed to automatically connect to Channel 1 and Channel 2.ġ. Thread the Antenna into the Antenna Connector on the back of the Camera. Turn the Power Switch to the ON position. Plug the Power Adapter into a 120VAC outletģ.

Connect the Power Adapter's cord to the back of the Receiver.Ģ.

Attach Receiver to Mounting Bracket, then loosen Adjustment Knobs, adjust Receiver as needed, then tighten Adjustment Knobs. Drive Screws through mounting holes in Base and into anchor holes until the Mounting Bracket is securely attached to the mounting surface.ĥ. Position Mounting Bracket so that Mounting Holes align with anchor holes.Ĥ. Tap Anchors into the holes until they are almost flush with mounting surface.ģ. Using a drill bit slightly smaller than the Anchors, drill holes in the marked locations.Ģ. Is securely attached to the mounting surface.Ĥ. Drive Screws through mounting holes in Base and into pilot holes until the Mounting Bracket Position Mounting Bracket so that mounting holes align with pilot holes.ģ. Using a drill bit slightly smaller than the Screws, drill pilot holes into the marked locations.Ģ. Using the Base as a template, mark locations of mounting holes on mounting surfacġ. Adjust the Stand until desired position is achieved. Make sure the location will remain within the Receiver's Operating Temperature. Take into consideration the length of the Power Adapter's cord.ĬAUTION! Route the cord so as to avoid a tripping hazard.Ĥ. Select a clean, dry location indoors with a 120V outlet nearby.ģ. Verify that installation surface has no hidden utility lines before drilling or driving screws.Ģ. Thread the Antenna into the Antenna Connector on the back of the Receiver. Owner 's Manual Surveillance System Receiver Components and Controlsįor technical questions, please call 1-88. Bunker Hill Security 62368 - 4 Channels Wireless Surveillance System - Use Manual - Use Guide PDF.

How to connect bunker hill security camera to computer